Peel and stick flashing.
Sidewall roof flashing.
The flashing extends onto the roof a minimum of 2 inches 4 inches is preferable in more severe climate areas.
Flashing joints are lapped 6 in the direction of water flow.
The wall side of the flashing can either be covered over with siding or sealed with caulk.
For counter flashing i cut and bent mine from a roll of 10 valley flashing.
Universal sidewall trim is designed to flash from your metal roof panels to a vertical wall such as a chimney.
Universal sidewall trim is designed to flash from your metal roof panels to a vertical wall such as a chimney.
The flashing extends up the wall at least 4.
The universal sidewall trim combined with sealant provides a watertight seal for your roof system.
Sidewall flashing is applied when the side of the roof butts up against an adjacent wall.
Striations and bends on the flashing provide strength and match the lines of your other edge trims.
Proper installation of flashing and counter flashing at the intersection of a vertical wall with a roof surface is required to avoid roof leaks.
Not really a good idea but the previous set up did this i did not.
Nailing the step flashing into the roof shingles.
Butyl tape should be applied where the foot of the flashing attaches to the roof.
Striations and bends on the flashing provide strength and match the lines of your other edge trims.
